Estado do Produto: Novo
The NI-900 unit is designed to control and automate a variety of devices in single rooms or multiple small rooms and is capable of supporting devices with a variety of communication formats. It is configured to control a limited number of lights, thermostats, video displays and other equipment.
Perfect for single rooms or two or more small rooms with a limited number of devices such as home theaters, MDUs, hotel rooms and other environments.
1 Configurable RS-232 / RS-422 / RS-485 Serial port
3 IR / Serial ports
1 IR Receiver Port
4 Digital I/O ports
2 Communication Networks: AxLink and Ethernet (TCP/IP)
304 MIPS processor speeds
64 MB RAM
32 MB Flash Memory
512 KB Non-Volatile Memory
AMX Device Discovery enabled
1 9/16" x 5 9/16" x 5 1/8" (4.01 cm x 14.10 cm x 13 cm)
1.30 lbs (590 g)
300 mA @ 12 VDC
Power requirements are usage dependant
Metal with black matte finish
FCC Part 15 Class B, CE, and IEC 60950
FRONT PANEL COMPONENTS
Configuration DIP Switch: Sets the communication parameters for the Program port
IR RX LED: Red LED lights when IR data is being received via the rear IR RX port
IR LEDs: Three red LEDs light during the transmission of IR or Serial data via the rear IR port
I/O LEDs: Four yellow LEDs light when the rear I/O channels 1 - 4 are active. LED indicator for each I/O port reflects the state of that particular port
LINK/ACT: Green LED lights when the Ethernet cable is connected and an active link is established. This LED also blinks when receiving Ethernet data packets
Status: Green LED lights when the Controller is programmed and communicating properly
Output: Red LED lights when the Controller transmits data, sets channels sends data strings, etc.
Input: Yellow LED lights when the Controller receives data from button pushes, strings, commands, channel levels, etc.
ID Pushbutton: Sets the NetLinx ID (Device only) assignment for the device
REAR PANEL CONNECTORS
RS-232/422/485 (Port 1)
IR RX (Port 6)
Digital I/O (Port 5)
IR/Serial (Ports 2-4)
AxLink Port: 4-pin 3.5 mm mini-Phoenix (male) connector provides data and power to external control devices
Ethernet Port: RJ-45 port for 10/100 Mbps communication. LEDs show communication activity, connection status, speeds, and mode information: - SPD (speed) - Yellow LED lights On when the connection speed is 100 Mbps and turns Off when the speed is 10 Mbps. - L/A (link/activity) - Green LED lights On when the Ethernet cables are connected and terminated correctly, and blinks when receiving Ethernet data packets.
Power Port: 2-pin 3.5 mm mini-Phoenix (male) connector
Operating Temperature: 0° C (32° F) to 50° C (122° F)
Operating Humidity: 20% to 85% RH
Heat Dissipation (Typical): 12.3 BTU/hr
Three CC-NIRC IR Emitters